Limited Time Offer !

• Bivolt Command board (127V or 220V)

• Control PPA motors with brushless synchronous type with a permanent magnet in the rotor (BLDC - Brushless DC) of 220V

• Digital or Hybrid limit switch System

• EEProm (removable) memory that stores the codes of the Transmitters recorded in encrypted form

• Compatible with Rolling Code transmitters with their own PPA protocol

• Built-in radio receiver

• Inputs for a single receiver, buttonhole, photocell, lock module, and garage light module

• DIP programming

• Leaf Delay function for swing gate openers;

• Automatic dual voltage (Auto range) power supply (127VAC/220VAC, 50 / 60Hz);

• Switched-mode power supply that provides the accessories with 15V / 400mA;

• Soft Charging circuit for the capacitors of the variable frequency drive's power amplifier;

• Protection against the electric charge in both common and differential mode by a varistor;

• Motor's power amplifier uses an IGBT module and driver;

• EEPROM Memory for storing both added remote controls and the control board setup;

• Input port for opening/closing photocell, opening/closing command; input port for pushbutton and the loose receiver;

• Output port for Electric lock and Courtesy light;

• Communication with the UPS for reduction of electric power consumption when a battery is the primary power source;

• Compatible with PROG and BLUE (CONNECT line);

• Positioning system by both encoder and magnetic reeds (HYBRID system);

• RF receiver on-board;

• Compatible with both Rolling / Fixed Code remote controls. residential commercial ppa gate opener Miami Fort Lauderdale Florida City

• Control of AC motors

• Bivolt Command board (127V / 220V)

• Frequency inverter

• Digital or Hybrid limit switch System

• EEProm (removable) memory that stores the codes of the Transmitters recorded in encrypted form

• Compatible with Rolling Code transmitters with own PPA protocol

• Built-in radio receiver

• Inputs for a single receiver, pushbutton, photocell, open command, close command, lock module, and garage light module

• Programming by DIP, PROG, BLUE, and SPIRIT

• Stand-by function that increases autonomy with No break

• Input voltage Bivolt (100 – 240V)

• Inverter for Brushless DC 24V motors

• Digital or hybrid limit switch system

• Compatible with Rolling Code Transmitters with PPA's own protocol

• Built-in radio receiver

• Inputs for a single receiver, pushbutton, photocell, lock module, and garage light module

• Programming via PROG and PROG APP

• Operation with 12V stationary battery (optional)

• Capacity up to 100 controls (Fixed or Rolling)

• Input voltage Bivolt (127V / 220V)

• Frequency Inverter for Induction Motors

• Digital or hybrid limit switch system

• Compatible with Rolling Code Transmitters with PPA's own protocol

• Built-in radio receiver

• Inputs for a single receiver, pushbutton, photocell, lock module, and garage light module

• Programming via PROG

• Capacity up to 100 controls (Fixed or Rolling)

• Full Range AC Power Supply (100 – 240V);

• Analog Limit Switch System;

• RF receiver on-board;

• EEPROM Memory for storing both added remote controls and the control board setup;

• Setup by pushbutton switches and eight levels by LEDs;

• Up to 256 remote controls;

• Electronic clutch (strength) adjustment;

• Automatic acquiring (O/C path);

• Input ports for photocell and pushbutton;

• Output ports for the receiver / electric lock and courtesy light modules;

• Brake adjustment;

• Independent adjustment of the travel stop ramp (Open and closed);

• Preset opening delay when a traffic light is used;

• Compatible with PROG

• Frequency inverter for Brushless motors;

• • Automatic bivolt control center;
• • 127VAC/220VAC 50 or 60 Hz;
• • Compatible with standard Safe Code transmitters with PPA protocol and fixed code;
• • Switched power supply, provides 15V / 400mA for accessories;
• • Lock output, light;
• • Open and close command inputs, open only, only close individual RF receiver;
• • Individual opening photocell and closing photocell inputs;
• • Built-in 433.92Mhz receiver;
• • Compatible with PROG;
• • Compatible with Connect and PPA ON line devices;
• • Graphic display with programmable functions.
• Product Number: A22619

PPA Facility TOP Control Board

• • Digital, Analog, or Hybrid End of Course System;
  • Radio frequency (RF) receiver incorporated into the Central board;
  • Code learning of up to 160 different transmitters independent of buttons;
  • Inputs for Photocell and separate RF receiver module;
  • Outputs for a signal module, lock module, and garage light module;
  • Soft start;
  • Electronic clutch;
  • Electronic brake;
  • Pulsating torque;
  • Slowdown at the end of the course (digital or hybrid mode).

•  • Input voltage Bivolt (100 – 240V)
  • Inverter for Brushless DC 24V motors
  • Digital or hybrid limit switch system
  • Compatible with Rolling Code Transmitters with PPA's own protocol
  • Built-in radio receiver
  • Inputs for a single receiver, pushbutton, photocell, lock module, and garage light module
  • Programming via PROG and PROG APP
  • Operation with 12V stationary battery (optional)
  • Capacity up to 100 controls (Fixed or Rolling) 

Product Number: A21867